The material: 'EVO 719' you were looking for has been superseded by the one below.

Biopolymer EVO 719

Want to keep this datasheet? Save it now in your required format


Extrusion grade bio resin & industrial compostable.

This material data has been provided by Indochine Bio Plastiques (ICBP) Sdn. Bhd..

All metrics apply to room temperature unless otherwise stated. SI units used unless otherwise stated.
Equivalent standards are similar to one or more standards provided by the supplier. Some equivalent standards may be stricter whereas others may be outside the bounds of the original standard.

Ashby charts




Bio-based content

100 %

Show Material materials with Bio-based content of 100 %


1.3 g/cm³

Show Material materials with Density of 1.3 g/cm³




30.0 %

Show Material materials with Elongation of 30.0 %

Flexural modulus

2.0 GPa

Show Material materials with Flexural modulus of 2.0 GPa

Flexural strength

65.0 MPa

Show Material materials with Flexural strength of 65.0 MPa

Hardness, Shore D

70.0 [-]

Show Material materials with Hardness, Shore D of 70.0 [-]

Impact strength, Izod unnotched, ASTM

20.0 J/m

Show Material materials with Impact strength, Izod unnotched, ASTM of 20.0 J/m

Tensile strength

40 MPa

Show Material materials with Tensile strength of 40 MPa



Decomposition heat

220.0 J/g

Show Material materials with Decomposition heat of 220.0 J/g

Melting point

140 °C

Show Material materials with Melting point of 140 °C

Rheological Properties


Melt mass-flow rate

8 g/10min

Show Material materials with Melt mass-flow rate of 8 g/10min


Technological properties

Application areas

Straw, tube


Food Contact: Halal

Processing methods

1. Purge the machine using LDPE/HDPE material at original processing temperature. 2. Lower the temperature to 130 -150°C. 3. Purge the ICBP Bio Resin EVO grade at temperature of 125 - 145°C. 4. Properly adjust according to the conditions of machine and finished product.