Pebax® C 63C73 SP 01

Alternative and trade names
Want to keep this datasheet? Save it now in your required format


Polyether block amide Pebax® C 63C73 SP 01 resin is a thermoplastic elastomer made of flexible polyether and rigid polyamide based on renewable resources. This SP grade has been developed to be heat and UV resistant.

Pebax® C is the new route explored to design cost-efficient components while preserving Pebax® resin key features. The percentage of renewable carbon according to ASTM D6866 (calculated) is 51%.

This material data has been provided by Arkema Technical Polymers.

"Typical" values were obtained via a literature search. "Predicted" values were imputed via artificial intelligence technology. While we have placed significant efforts in ensuring data accuracy, "typical" and "predicted" data should be considered indicative and verified by appropriate material testing. Please do contact us if additional information on the the predicted data method is required.
All metrics apply to room temperature unless otherwise stated. SI units used unless otherwise stated.
Equivalent standards are similar to one or more standards provided by the supplier. Some equivalent standards may be stricter whereas others may be outside the bounds of the original standard.

Ashby charts



PropertyValueConditionTesting Standard

Bio-based content

51 %

Show Supplier Material materials with Bio-based content of 51 %


1.07 g/cm³

Show Supplier Material materials with Density of 1.07 g/cm³


ISO 1183


PropertyValueConditionTesting StandardComment

Hardness, Shore D

61 [-]

Show Supplier Material materials with Hardness, Shore D of 61 [-]


ISO 7619-1

15 seconds

Impact strength, Charpy notched

No Break at 23°C


ISO 179/1eA

Impact strength, Charpy unnotched

No Break at 23 and -30°C


ISO 179/1eU

Yield strength

43 MPa

Show Supplier Material materials with Yield strength of 43 MPa


ISO 527-1/-2


PropertyValueConditionTesting StandardComment

Melting point

218 °C

Show Supplier Material materials with Melting point of 218 °C


ISO 11357-1/-3


Rheological Properties

PropertyValueConditionTesting StandardComment


0.9 %

Show Supplier Material materials with Shrinkage of 0.9 %


ISO 294-4

1.3 %

Show Supplier Material materials with Shrinkage of 1.3 %


ISO 294-4


Technological properties

Application areas

Footwear - Outsoles

Processing methods

Injection Molding:

  • Typical melt temperature (Min / Recommended / Max): 250°C / 270°C / 290°C.
  • Typical mold temperature: 30-60°C.
  • Drying time and temperature (only necessary for bags opened for more than two hours): 4-8 hours at 60-70°C.

  • Do you have a technical question or need more information about this material?

    Post it as a comment below and receive answers from engineers and other community members.