Rilsan® BESN BLACK P123 TL

Alternative and trade names
PA11
Want to keep this datasheet? Save it now in your required format

Description

PA11, EHLN, 22-010

Rilsan® BESN BLACK P123 TL resin is a flexible polyamide 11 produced from a renewable source. This black grade is designed for extrusion typically for cooling application and for Adblue circuits (SCR). The percentage of renewable carbon according to ASTM D6866 (calculated) is 98%.

This material data has been provided by Arkema High Performance Polymers.

All metrics apply to room temperature unless otherwise stated. SI units used unless otherwise stated.
Equivalent standards are similar to one or more standards provided by the supplier. Some equivalent standards may be stricter whereas others may be outside the bounds of the original standard.

Ashby charts

Properties

General

PropertyTemperatureValueComment

Bio-based content

98 %

Show Supplier Material materials with Bio-based content of 98 %

ASTM D6866

Density

23.0 °C

1 g/cm³

Show Supplier Material materials with Density of 1 g/cm³

ISO 1183

Mechanical

PropertyTemperatureValueComment

Elongation

23.0 °C

50 %

Show Supplier Material materials with Elongation of 50 %

min., ISO 527-1/-2, nominal, Conditioned

Elongation at yield

23.0 °C

33 %

Show Supplier Material materials with Elongation at yield of 33 %

ISO 527-1/-2, Conditioned

Yield strength

23.0 °C

25 MPa

Show Supplier Material materials with Yield strength of 25 MPa

ISO 527-1/-2, Conditioned

Thermal

PropertyValueComment

Melting point

189 °C

Show Supplier Material materials with Melting point of 189 °C

ISO 11357-1/-3, 10°C/min

Technological properties

Property
Application areas

Main applications:

  • Cooling application
  • Adblue circuits (SCR)
  • Auto - Water Cooling Circuit, Emission Control Systems, SCR Lines and Tanks

  • Other

    Packaging:

  • This grade is delivered dried in sealed packaging (25 kg bags) ready to be processed.

    Shelf Life:

  • Two years from the delivery. For any use above this limit, please refer to our technical services.

  • Processing methods

    Injection Molding:

  • Typical melt temperature (Min / Recommended / Max) : 260°C / 275°C / 290°C.
  • Drying time and temperature (only necessary for bags opened for more than two hours) : 4-8 hours at 80-90°C.