General
Property | Temperature | Value | Comment |
---|---|---|---|
Density | 23.0 °C | 1.1 g/cm³ Show Supplier Material materials with Density of 1.1 g/cm³ | ASTM D792 |
Mechanical
Property | Temperature | Value | Comment | ||
---|---|---|---|---|---|
Elongation | 23.0 °C | 200 % Show Supplier Material materials with Elongation of 200 % | ASTM D412 | ||
Hardness, Shore D | 23.0 °C | 50 [-] Show Supplier Material materials with Hardness, Shore D of 50 [-] | ASTM D2240 | ||
Tensile strength | 23.0 °C | 18 MPa Show Supplier Material materials with Tensile strength of 18 MPa | ASTM D412 | ||
Impact strength, Izod unnotched, ASTM | No Break |
Thermal
Property | Value |
---|---|
Flammability | UL 94 V-0 |
Electrical
Property | Temperature | Value | Comment |
---|---|---|---|
Dielectric constant, 1MHz | 23.0 °C | 2.7 [-] Show Supplier Material materials with Dielectric constant, 1MHz of 2.7 [-] | ASTM D150 |
Dielectric strength | 23.0 °C | 28 kV/mm Show Supplier Material materials with Dielectric strength of 28 kV/mm | ASTM D149 |
Dissipation factor, 1MHz | 23.0 °C | 4E-3 [-] Show Supplier Material materials with Dissipation factor, 1MHz of 4E-3 [-] | ASTM D150 |
Volume resistivity | 23.0 °C | 1.00E+19 Ω·cm Show Supplier Material materials with Volume resistivity of 1.00E+19 Ω·cm | min., ASTM D257 |
Technological properties
Property | ||
---|---|---|
Application areas | Wire & Cable applications | |
Processing methods | Injection Molding, Extrusion. Pre-drying: 70-80°C for 4-8 Hours, Injection Temperature: 190-240°C, Extrusion Temperature: 180-230°C, Injection pressure: 40-60MPa, Filter: 100-200 mesh |