Properties
General
| Property | Temperature | Value | Comment |
|---|---|---|---|
Density | 23.0 °C | 1.2 g/cm³ Show Supplier Material materials with Density of 1.2 g/cm³ | ASTM D792 |
Mechanical
| Property | Temperature | Value | Comment |
|---|---|---|---|
Elongation | 23.0 °C | 450 % Show Supplier Material materials with Elongation of 450 % | ASTM D412 |
Hardness, Shore A | 23.0 °C | 95 [-] Show Supplier Material materials with Hardness, Shore A of 95 [-] | ASTM D2240 |
Tensile strength | 23.0 °C | 28 MPa Show Supplier Material materials with Tensile strength of 28 MPa | ASTM D412 |
Thermal
| Property | Value |
|---|---|
Flammability | UL-1581 VW-1 |
Electrical
| Property | Temperature | Value | Comment |
|---|---|---|---|
Dielectric constant, 1MHz | 23.0 °C | 5 [-] Show Supplier Material materials with Dielectric constant, 1MHz of 5 [-] | ASTM D150 |
Dielectric strength | 23.0 °C | 17 kV/mm Show Supplier Material materials with Dielectric strength of 17 kV/mm | ASTM D149 |
Dissipation factor, 1MHz | 23.0 °C | 0.05 [-] Show Supplier Material materials with Dissipation factor, 1MHz of 0.05 [-] | ASTM D150 |
Volume resistivity | 23.0 °C | 1.00E+14 Ω·cm Show Supplier Material materials with Volume resistivity of 1.00E+14 Ω·cm | min., ASTM D257 |
Technological properties
| Property | ||
|---|---|---|
| Processing methods | Pre-drying: 80°C for 4-8 hr, Injection temperature: 170-190°C, Extrusion temperature: 170-180°C, Injection pressure: 40-60MPa, Filter: 100-200 mesh | |