The material: 'Polyethylene Terephthalate (PET) Granule (ES306312)' you were looking for has been superseded by the one below.

VYPET™ VNT-917 MG

Alternative and trade names
PET-GF17

Want to keep this datasheet? Save it now in your required format

Description

Polyethylene Terephthalate (PET) with 17% Glass Fiber Reinforced. Contains a minimum of 70% Post-consumer resin

This material data has been provided by Lavergne.

All metrics apply to room temperature unless otherwise stated. SI units used unless otherwise stated.
Equivalent standards are similar to one or more standards provided by the supplier. Some equivalent standards may be stricter whereas others may be outside the bounds of the original standard.

Ashby charts

All categories

Properties

General

Property	Value	Temperature	Comment
Density	1.43 g/cm³ Show Supplier Material materials with Density of 1.43 g/cm³ at 23.0 °C	23.0 °C	ASTM D792

Mechanical

Property	Value	Temperature	Comment
Flexural modulus	6 GPa Show Supplier Material materials with Flexural modulus of 6 GPa at 23.0 °C	23.0 °C	ASTM D790
Flexural strength	160 MPa Show Supplier Material materials with Flexural strength of 160 MPa at 23.0 °C	23.0 °C	ASTM D790
Impact strength, Izod notched, ASTM	70 J/m Show Supplier Material materials with Impact strength, Izod notched, ASTM of 70 J/m at 23.0 °C	23.0 °C	ASTM D256
Tensile strength	105 MPa Show Supplier Material materials with Tensile strength of 105 MPa at 23.0 °C	23.0 °C	ASTM D638

Thermal

Property	Value	Temperature	Comment
Ash content	17 % Show Supplier Material materials with Ash content of 17 % at 23.0 °C	23.0 °C	ASTM D5630
Heat deflection temperature, 1.80 MPa	205 °C Show Supplier Material materials with Heat deflection temperature, 1.80 MPa of 205 °C		ASTM D648

Technological properties

Property
Application areas	Automotive structural applications (e.g. headlamps) and electrical components (e.g. brackets).
Certifications	RoHS,RECH,ULE Environmental Claims Validation
Color	Black
Fillers	17% Glass Fiber and Mineral Powder
Processing methods	Drying to Dew Point:-18°C or lower Feed zone: 260-270°C Middle zone: 265-290°C Front zone: 270-295°C Nozzle: 280-300°C Melt temperature: 275-290°C Mold temperature (thick wall parts): 25-40°C Mold temperature (thin wall parts): 95-120°C Injection Pressure: Medium Injection Speed: Medium Back Pressure: Low Screw Speed: Medium

The material: 'Polyethylene Terephthalate (PET) Granule (ES306312)' you were looking for has been superseded by the one below.

VYPET™ VNT-917 MG

Description

Ashby charts

Materials by this supplier

Use cases

Properties