Corroplast FM homogenous microstructure and the very good machinability result in increased productivity without loss of quality. No obstruction of the water flow rate and heat dessipation or algae growth in the cooling bore holes due to corrosion products. Its good thermal conductivity results in a high cyclic time.
Density
ρ7.6 g/cm³ at 23 °C
Coefficient of thermal expansion
α8.5E-6 1/K at 100 °C
for 20°C to the mentioned temperature
Thermal conductivity
λ22.2 W/(m·K) at 23 °C
Element
Weight %
Comment
-
Balance
-
Plus additions
12.8 %
1.6 %
0.25 %
Application areas
Complex base plates and mould frames with highest demands on machinability and resistance to condensation and cooling water (All-Stainless-Concept), plastic moulds without special requirements on polishability.
Corrosion properties
Consistent corrosion resistance: Even when additional corrosion resistance materials are used, which combined with other steels would have triggered contact corrosion
General machinability
Good stability despite time-consuming machining of the raw material: Even for filigree componenets and limited cavity spacing.
This material data has been provided by Deutsche Edelstahlwerke Specialty Steel (DEW).