Biopolymer Injicera CPX 902

Want to keep this datasheet? Save it now in your required format


Injection grade bio resin developed to process molded products.

This material data has been provided by Indochine Bio Plastiques (ICBP) Sdn. Bhd..

All metrics apply to room temperature unless otherwise stated. SI units used unless otherwise stated.
Equivalent standards are similar to one or more standards provided by the supplier. Some equivalent standards may be stricter whereas others may be outside the bounds of the original standard.

Ashby charts




Bio-based content

100 %

Show Material materials with Bio-based content of 100 %


1.27 g/cm³

Show Material materials with Density of 1.27 g/cm³




2.5 %

Show Material materials with Elongation of 2.5 %

Flexural modulus

2.63 GPa

Show Material materials with Flexural modulus of 2.63 GPa

Flexural strength

81.0 MPa

Show Material materials with Flexural strength of 81.0 MPa

Hardness, Shore D

58.0 [-]

Show Material materials with Hardness, Shore D of 58.0 [-]

Impact strength, Izod unnotched, ASTM

8.0 J/m

Show Material materials with Impact strength, Izod unnotched, ASTM of 8.0 J/m

Tensile strength

55 MPa

Show Material materials with Tensile strength of 55 MPa



Max service temperature

250.0 °C

Show Material materials with Max service temperature of 250.0 °C

Melting point

170 °C

Show Material materials with Melting point of 170 °C

Rheological Properties


Melt mass-flow rate

40 g/10min

Show Material materials with Melt mass-flow rate of 40 g/10min


60 g/10min

Show Material materials with Melt mass-flow rate of 60 g/10min


Technological properties

Application areas

Molded products, cutleries, tableware (<100°C)


Food Contact: Halal

Processing methods

1. Clean extruder with general purpose polypropylene or polystyrene. 2. Vacuum out hopper system to avoid contamination and make sure that the humidity of the air is below 40°C at dew point. 3. Introduce ICBP Bio Resin in to the extruder at the operating conditions used in the first step. 4. Once ICBP Bio Resin has been purged, reduce barrel temperatures to desired set points. 5. At shutdown, purge machine with PP or PS.